I tried printing something on my bambu instead of my voron since I cant get the voron working properly. Why do the outer walls do this?
You must log in or register to comment.
Is the filament dry?
That the default petg profile? Bump up your temperature by 10C and try again. Their PETG profile is too cold for the flow rate.
I actually lowered it to 250 and turned off the fan and it didn’t help.
Wrong way to adjust, try printing at 265 and keep the part fan on ( aux fan off).
the spool says not to exceed 250
Run a temp tower if you are worried about it, but I run all PETG at 265 on my P1S. 255 will tear like you show and print matte which means it isn’t properly melted.
Here’s the thing about temperature sensors, they vary.
If I have to guess, it looks like compression. Either you are over extruding or your print head is too close.
