All were obviously 3D printed. Layer lines were very clean. Even saw a kid walking around with one in hand hugging his parents to buy it for him.
All were obviously 3D printed. Layer lines were very clean. Even saw a kid walking around with one in hand hugging his parents to buy it for him.
Just curious opp - what was the price of some of these?
They were running at $9.99 if I remember correctly. Just finished a 5 hr drive, the stopover at Cracker Barrel was a pitstop en route.
My daughter’s friend got a 3d printer for Christmas (K1C) and started making bank printing anything he could find free off Cults.
This little kid - think he is 12 - is printing those dragons and everything else imaginable and taking them to school and selling them to classmates.
Am pretty sure my daughter told me that he was selling them from $20 up to some of his classmates. Whereas chump me will give them to friends for free.
There’s probably some sort of lesson to be taught here, but hell I respect the hustle.
not OP but they seem to retail those for around $11
$11 is way cheaper than i would have imagined for something that requires 5-6 hours of printing (on a $500-$1000 printer; the depreciation needs to be factored in the price), $2 of silk PLA, $2 of custom box and $5 of retailer markup
It says “imported” so probably made for a fraction of that in China.
ding ding ding
Hector Salamanca? Is that you?
Doing forget possible post processing, and factoring the cost of possible print fails.
If it was made by Hasbro it would be $1.75 of retailer markup and be told you are lucky enough to be blessed to carry hasbro products.
Only a matter of time before they scoop up GW and start suing like Nintendo. 🤮